Framing the bathroom walls...

I began the framing of the bathroom walls because I wanted to have additional stability for the utility shelves that I had just built. The left edge of the utility shelves was sagging a bit.

I had to make a cutout for the metal wheel well cover in the wood that creates the first bathroom wall. I covered the wall with the super thin Luan board that I mentioned before.


I intend on making two more walls for the bathroom but I'll have to wait on them until I get more wood.

You may have noticed that the offset vent is perfectly set above where the bathroom is located. This is exactly why a good plan is always best before taking on a project like this. :)

Click HERE to see a slide show of the photos from this post.